Dishnet reflector 2 manual#
Dishnet reflector 2 tv#

I have a regular roof mount tripod that I modified to make it easier to setup. Its less susceptible to rain fade and weak signals if youвЂ™re pointing through shrub, trees, or are on the edge of a spot beam. The antenna has a larger reflector and provides you with a stronger signal.

Dishnet reflector 2 manual#

This is a manual antenna, it doesnвЂ™t auto point, but offers a larger antenna for better signals. This allows the use of one coax cable to the receiver rather than two or three. The LNB assembly on the antenna has a built in switch that is controlled by the receiver. The VIP222 receiver uses all three satellites, depending what channels youвЂ™re watching. The 3 LNB antenna receives signals from three satellites, 110, 119, and 129. and are then locked into place with a thumb screw. When setting up, the smaller diameter tube (antenna) slides down inside the larger tube (tripod). I also modified the mast tubes that mount the antenna to the tripod, a larger diameter tube stays with the tripod, and a smaller diameter tube stays with the dish. I replaced all the nuts with wing nuts to make assembly and adjustments easier. tin foil, to block the LNBs while aiming.ДЄLSO вЂ“ I made some minor modifications to the antenna and tripod to make assembly, adjusting, and leveling a lot easier and more convenient. You could use any metallic object that blocks the signal, i.e. the mast MUST be level.Дў Cat food cans вЂ“ these are used to cover the two outside LNBs when aiming. This is probably the most important tool. It temporary connects between the LNBs and the receiver when pointing the dish antenna.Д«ubble level вЂ“ this one has a magnet on it to hold it to the mast while leveling. Squawk Meter вЂ“ This is an inexpensive meter that shows signal strength and has an audio tone when its pointed at a satellite. I use these tools to set up and point the antenna.Д¬ompass вЂ“ This is used to find the general direction to point the antenna.

Using a tripod has advantages, We can position it anywhere that has a clear view of the southern sky, and it only takes a few minutes to set up, point it, and start watching TV. This is a 3 LNB antenna purchased on e-bay that included a tripod, squawk meter, cable, and some other accessories. While traveling, I use a Dishnet 1000.2 antenna, this is identical to the antenna we use at home. no problems from these two locations, but I suspect we were at the very eastern edge of coverage for the western arc. The farthest north east weвЂ™ve used it has been in Washington DC and Virginia Beach, VA. If you are in the upper north east part of the US, these may not work for you. I use the WESTERN ARC (sats 110, 119, 129) at home and while on the road. One coax cable runs from this switch out to the antenna where the antenna has an internal LNB switch to select which LNB the receiver wants to use.Д«efore disconnecting the home receiver, I marked all the cables, then took a photo of the cables. The 222 receiver uses an external LNB switch to switch between the LNBвЂ™s. Our VIP222 receiver uses the signals from three satellites that are received by the antennas Low Noise Feeds (LNB), 110, 119, and 129. We hit the US highways a few months out of the year with stops at different locations for a few days, a few weeks, even a month at one location. This article can apply regardless of what receiver you have. ItвЂ™s a fairly new HD dual receiver, two receiverвЂ™s in one. We use our Dish model VIP222 home receiver while on the road. Its already paid for, so no extra fees for a different receiver or any pay-as-you-go plan fees. Why not, no ones at home watching the home satellite, so why not use the home receiver while on the road. Although most of these travelers have a dedicated receiver / antenna system while traveling, we simply pack up our home receiver and hit the road.

Dishnet reflector 2 tv#

Many RVвЂ™ers travel the country roughing it with a satellite TV receiver. Traveling with our home Dishnet VIP222 receiver.